Skywalker roaster... | [275] |
Skywalker, the AL... | [186] |
Dereks 1-2Kg drum... | [115] |
Skywalker Roasts | [92] |
SR800/SR540 Fan C... | [82] |
Newbie question - Buttons on Artisan
|
|
rgb |
Posted on 04/12/2019 10:04 AM
|
Newbie Posts: 2 Joined: February 20, 2019 |
Is it possible to put more than one serial command the same line when using Artisan with TC4+? For example I wantt to use the START button to turn both the fan on and the heater on at the same time. The serial commands would be OT1;1 for the heater and OT2;1 for the fan. Can these be put on the same line? If so what would be the syntax? |
|
|
mg512 |
Posted on 04/12/2019 10:37 AM
|
1/4 Pounder Posts: 189 Joined: March 04, 2018 |
Yes, you can do that. Put "\n" between the commands, e.g. "OT1;1 \n OT2;1". |
|
|
rgb |
Posted on 04/12/2019 4:08 PM
|
Newbie Posts: 2 Joined: February 20, 2019 |
Many Thanks |
|
Jump to Forum: |
Thread | Forum | Replies | Last Post |
---|---|---|---|
Finally Switching to Artisan Roasterscope | Dataloggers/Controllers/Rate of Rise Meters | 17 | 02/28/2024 7:19 AM |
Pressure gauge question | Drum Roaster (Store Bought and Commercial) | 2 | 01/18/2024 8:03 PM |
Artisan 2 vs Roastime 4 | R1 Bullet Roaster | 3 | 01/08/2024 11:53 AM |
Solid State Relay Question | Dataloggers/Controllers/Rate of Rise Meters | 11 | 11/27/2023 9:16 AM |
Unable to get Artisan Scope's PID to control heating | Dataloggers/Controllers/Rate of Rise Meters | 4 | 08/01/2023 9:11 AM |