Homeroasters - Home Roasting Coffee Community » BUILDING A ROASTER » David and Alchemist Roaster Building Project
Who is here? 1 guest(s)
Page 3 of 3: 123
 Print Thread
Frame Design and Construction
Alchemist
Top  #51 Print Post
Posted on 07/21/2008 11:56 AM
Yes, you hit the same conclusion I did. I will design around making the corners three separate pieces and holding them together with the support.

The only real change is that I want to hold each piece in place with two fasteners (rivets) since we won't have the added support of the bent corner.

We will keep the bends to less than 90 degrees. 45 at most.
Alchemist attached the following image:
corner[1033].jpg
Edited by Alchemist on 07/21/2008 11:57 AM
 
Page 3 of 3: 123
Jump to Forum: