TC4 with aArtisan... | [411] |
Transparent Fluid... | [125] |
TC4 Roasting App | [69] |
Modifying DASH 14... | [35] |
RobotDyn AC Light... | [34] |
Artisan Devices
|
|
BobbyS |
Posted on 05/23/2017 5:26 PM
|
![]() 1/4 Pounder ![]() Posts: 179 Joined: July 02, 2011 |
Fuji has discontinued the PXR series of controllers and replaced them with the PXF series. Does anyone know if the PXF series of Fuji Controllers will work with Artisan? |
|
|
renatoa |
Posted on 05/29/2017 6:43 AM
|
![]() Administrator ![]() Posts: 1626 Joined: September 30, 2016 |
Thank you to open my eyes about this controller... investigated more and seems a very nice piece of gear... so I bought one from China, wjere you can find a lot of used such controllers for less than $50. Unfortunately, found later it is the ASCII version, not MODBUS... wondering if an Artisan expert can tell me if any chance to use it. As a programmer, seems that the decoded output of MODBUS can be obtained from ASCII stream too... Even not, it is still fine as ram/sink unit. DIY: TO based IR 750g
Moded commercial: Dieckmann RoestMeister, Nesco, popper(s). TC4ESP, MS6514, USB/Artisan/Apps, PID controllers Grinder: MBK Feldgrind, mod'ed Porlex to 47 conical burrs, vintage PeDe Dienes, Kinu M38 Gaggia Mini, Aeropress, drip |
|
|
fransg |
Posted on 05/30/2017 3:59 AM
|
![]() 1/4 Pounder ![]() Posts: 80 Joined: December 01, 2013 |
I see it's been replaced! The new one looks good too. http://kostverlor...-pxf4.html The PXG4 is still available it seems because a fellow FZ94 roaster owner just ordered one in the USA: http://kostverlor...-fz94.html HG One & Londinium I -- Mazzer Mini E & Rocket Giotto -- La Pavoni's -- Fracino Roastilino with PXG4 - Artisan - Tonino
|
|
Jump to Forum: |
Thread | Forum | Replies | Last Post |
---|---|---|---|
Using a TC4 with Artisan Roaster Scope | Dataloggers/Controllers/Rate of Rise Meters | 11 | 01/27/2021 10:56 AM |
Modification of a Drum Air Fryer into an Artisan-controlled Coffee Roaster | Building a Coffee Roaster | 5 | 01/27/2021 7:09 AM |
SOLVED: Artisan says: "Arduino could not set channels" | Dataloggers/Controllers/Rate of Rise Meters | 9 | 01/24/2021 2:14 AM |
Arduino and Artisan | Dataloggers/Controllers/Rate of Rise Meters | 4 | 01/21/2021 1:07 PM |
Artisan and Mastech 6514 | Dataloggers/Controllers/Rate of Rise Meters | 12 | 01/08/2021 2:52 AM |