Homeroasters - Home Roasting Coffee Community » BUILDING A ROASTER » Electric and Gas Heat Sources
Who is here? 1 guest(s)
 Print Thread
Help to improve my gas system.
aicardo
Top  #1 Print Post
Posted on 01/04/2019 1:40 PM
Hello.
My name is Pablo in from Colombia.
I am building a coffee roaster, is for 6 pounds of coffee, the thickness of the drum sheet is 1/8 inch and we are recycling the burner of a water heater.
As I show you in the photo below, my gas system is quite basic and does not allow me to have adequate gas control.
https://drive.goo...sp=sharing
but I need your help me, where I can buy all the elements of the system Lylabrown did. in USA

thanks

pablo
Edited by JackH on 01/04/2019 3:30 PM
 
allenb
Top  #2 Print Post
Posted on 01/06/2019 7:30 AM
Hi Pablo

It will help if you provide a link to the particular thread and post that pertains to the particular arrangement Lylabrown was working with. With this information we can help you nail down valve models he was working with.
1/2 lb and 1 lb drum, Siemens Sirocco fluidbed, presspot, chemex, cajun biggin brewer from the backwoods of Louisiana
 
aicardo
Top  #3 Print Post
Posted on 01/12/2019 12:27 PM
HI.
MY QUESTION IS, IF I WANT TO CONTINUE BY THE ROUTE OF MANUALLY CONTROLLING THE ROASTER, THAT ELEMTS I NEED TO IMPROVE MY GAS SYSTEM.
I AM DOING THIS TRANSLATION WITH GOOGLE AND NOT IF THE QUESTION IS CLEAR.
THANK YOU
PABLO
 
Jump to Forum: