Skywalker roaster... | [292] |
Skywalker, the AL... | [214] |
Skywalker Roasts | [94] |
Rainfrog's Roastm... | [53] |
My first popcorn ... | [47] |
Dryer Heaters
|
|
Husamka |
Posted on 09/12/2020 9:49 PM
|
1/4 Pounder Posts: 56 Joined: September 16, 2016 |
Hi, Anyone tried these Dryer Heaters for fluid bed roaster 240V or can advise. To be with vacuum motor and reducer to 2" or 1.5" for the size of 700 gr roaster. The Prose, they are good quality from a reputed company with years' life span, just similar to the dryer in your house which you forget about them. and the cons is the size of the housing which they need, Of course, this housing with heat insulation. They work with 240V for 5400 Watt and if with this voltage regulator, it can be reduced. with this quality, they are definitely made from Kanthal, not like these cheap heat gun heaters. I used this voltage regulator in series after SSR-TC4 to control the maximum wattage for the circuit breaker.
Husamka attached the following images:
Edited by Husamka on 09/13/2020 1:07 AM |
|
|
CharcoalRoaster |
Posted on 09/13/2020 8:26 AM
|
1 1/2 Pounder Posts: 640 Joined: April 13, 2012 |
I've incorporated that last dryer heater in my new build. I've installed a dedicated circuit in the garage to take advantage of the increased capacity. However, my Arduino/TC4/ZCD setup isn't set up properly yet so I haven't been able to test it. I have it housed in a large electrical conduit junction box surrounded by ceramic insulation What voltage regulator are you referring to? |
|
|
Husamka |
Posted on 09/13/2020 2:03 PM
|
1/4 Pounder Posts: 56 Joined: September 16, 2016 |
I have the first voltage regulator. and you can test your heater if you have a voltage regulator alone. Also, we can set a limit to the heater percentage in Artisan for instance 65% so the power goes maximum 3500 watts so no need for the regulator ( I didn't try this yet). If possible it will be useful to learn from photos inside your box or any details. The last one to the right looks slimmer which is better but these two with cylindrical housing looks need only proper reducers. https://www.aliexpress.com/item/33009535695.html?spm=a2g0s.9042311.0.0.27424c4dZYTE65 https://www.aliexpress.com/item/33006480806.html?spm=a2g0s.8937460.0.0.74dd2e0esMHdLS
Husamka attached the following image:
Edited by Husamka on 09/13/2020 4:12 PM |
|
Jump to Forum: |
Thread | Forum | Replies | Last Post |
---|---|---|---|
Dryer elements used in hot air roaster | Electric and Gas Heat Sources | 4 | 08/01/2023 8:13 AM |
Question about wiring a dryer element | Fluidbed Roaster | 5 | 02/04/2020 5:04 PM |
Dryer Ignitor Element Heat Output | Electric and Gas Heat Sources | 4 | 03/14/2017 7:09 PM |
Clothes Dryer Roaster | Drum Roasters | 10 | 09/30/2011 7:03 AM |
Heat Element (dryer) | Building a Coffee Roaster | 47 | 04/28/2010 9:26 PM |