Favorite Green Co... | [218] |
1-6 lbs Roaster B... | [25] |
These are the spe... | [24] |
DIY Kanthal A1 he... | [19] |
Both Manual and D... | [19] |
HGFS TC4+ LCD malfunction
|
|
Olly82 |
Posted on 05/19/2022 4:08 PM
|
![]() Newbie ![]() Posts: 14 Joined: April 15, 2022 |
https://imgur.com... Possibly SSR07-40240A too close to lcd? Edited by renatoa on 05/20/2022 2:06 AM |
|
|
renatoa |
Posted on 05/20/2022 2:09 AM
|
![]() Administrator ![]() Posts: 2191 Joined: September 30, 2016 |
I doubt, rather LCD data line from i2c adapter bad solder. You can check by disconnecting SSD, if still persist. |
|
|
Olly82 |
Posted on 05/20/2022 1:19 PM
|
![]() Newbie ![]() Posts: 14 Joined: April 15, 2022 |
So checked with my pwm regulator screen next to SSR. Goes grazy as well. |
|
|
renatoa |
Posted on 05/20/2022 2:23 PM
|
![]() Administrator ![]() Posts: 2191 Joined: September 30, 2016 |
How close is "next" ? I have 10 cm between the controller breadboard and dimmer board PCB, and no influence. |
|
|
Olly82 |
Posted on 05/21/2022 1:09 PM
|
![]() Newbie ![]() Posts: 14 Joined: April 15, 2022 |
Like physically couldn't place closer for test. But tc4+ lcd 6cm away gets affected. |
|
Jump to Forum: |
Thread | Forum | Replies | Last Post |
---|---|---|---|
Fresh Roast 540 Fan malfunction | Fresh Roast 8 and NEW SR 500 | 1 | 07/03/2021 9:48 AM |
Miele CVA 4070 Cleaning Malfunction | Preparing Coffee | 7 | 01/19/2015 2:32 PM |
Poppery 2 Malfunction? | Popcorn Popper roasting | 6 | 08/31/2013 4:12 PM |