Favorite Green Co... | [218] |
1-6 lbs Roaster B... | [25] |
These are the spe... | [24] |
DIY Kanthal A1 he... | [19] |
Both Manual and D... | [19] |
The distance between the heating element and the inlet mesh?
|
|
walk |
Posted on 02/18/2022 8:49 AM
|
![]() Newbie ![]() Posts: 13 Joined: February 08, 2022 |
I need to design a heating element holder for fb roaster. Plan is to fit a temperature sensor between the heater and the inlet mesh, which takes about 20 mm. Should this distance be increased for any reason? Heating element is the typical heat gun one. I have a difficult challenge to fit between the stove and the hood, every millimeter is counted. Edited by walk on 02/18/2022 10:05 AM |
|
Jump to Forum: |
Thread | Forum | Replies | Last Post |
---|---|---|---|
DIY Kanthal A1 heating coil | Heat Gun Roasting | 20 | 06/23/2022 6:24 AM |
1/2 lb - Heat Gun Element - Tc4+ - Fluidbed Roaster | Fluidbed Roaster | 20 | 05/22/2022 11:07 AM |
Repairing/replacing heating element | Popcorn Popper roasting | 8 | 05/08/2022 3:09 AM |
Heating elements | Fluidbed Roaster | 4 | 02/20/2022 4:43 AM |
B-A-R heating element | Fluidbed Roaster | 5 | 02/16/2022 10:50 AM |